Looks great!

If your are looking for pur aesthetics, I would recommend trimming the resistors/leds, and bending their leads before putting them on.

If you’d like some inspiration this guy has some of the best looking hand crafted electronics I’ve ever seen.

Nice! Could you explain what it is or where to find more information about it? I was not able to find information online

We are working towards having a product properly packaged. This is a prototype that is not mature enough yet to justify the cost/time to package it. Moreover, this custom chip is used to measure ultra low currents (down to femto amps), so any packaging could potentially interfere with the measurement capabilities (-> no epoxy). It is however protected by a large shielding box, but it’s no use during assembly/modifications :/

The little gray wires should be all nice and straight. Even though your chip may be a good boi, touching it will wreak havoc on the wire bonding. Repairing the damage shown on the picture takes a skilled worker and very expensive equipment. Even then the repair is not fully guaranteed to be successful.